Difference between revisions of "Minibot Controller/XL-320"
From Lofaro Lab Wiki
Line 44: | Line 44: | ||
[[File:Minibot_Controller_(8).png]] | [[File:Minibot_Controller_(8).png]] | ||
+ | [[File:Minibot_Controller_(9).png]] | ||
[[File:Minibot_Controller_(10).png]] | [[File:Minibot_Controller_(10).png]] | ||
[[File:Minibot_Controller_(11).png]] | [[File:Minibot_Controller_(11).png]] |
Revision as of 12:51, 17 April 2015
This is the instruction of building the controller for Minibot.
Notes :
- The zero positions will be placed as same as how Minibot is assembled
- - Instruction of Minibot indicates to place zero positions to be at top.
- There are only one arm in the instruction.
- Face the servo as shown in image for one arm.
- Another arm will be mirrored to the instruction.
- 2-step rivets are used for all instruction except indicated section.
3D printing :
- STL files are uploaded here.
- You might need to convert STL files to 3D printable file.
The claw
- For movable part of the hand, one of the side of servo will not have wheel; Connect Servo with the hand by putting rivet in the middle hole only.
- On the other side of the servo, For upper hand, put rivets on outer holes.
Forearm
- Before connecting next part, Connect wire to the servo. Then connect Forearm.
- As Previous part, connect wire before putting forearm.
- Connect Elbow part, similar as you put the upper hand, put 4 rivets on side with wheel, and 1 on the other side.