Difference between revisions of "3D Printing (SLA)"
From Lofaro Lab Wiki
Line 34: | Line 34: | ||
===SLA Printing Set up=== | ===SLA Printing Set up=== | ||
− | [[File:Resin.png|thumb|center| | + | Before sending your file to the printer be sure to check the resin container and make sure the vent is open which is seen as a small black cap that is flipped open nest to the resin container. |
− | [[File:Ready to Print.png|thumb|center| | + | [[File:Resin.png|thumb|center|300px]] |
+ | |||
+ | Upload your file using the USB cable attached to the printer. | ||
+ | [[File:Ready to Print.png|thumb|center|300px]] |
Revision as of 16:42, 27 January 2018
Contents
Overview
Learn how to use, maintain and operate SLA based 3D printers specifically the FormLabs printer Form 2.
Prerequistes
- 3D CAD Modeling Fusion 360
=Software Required
What you will learn
- Export 3D models to 3D printer compatible formats
- Load and unload resin
- How to start a print on Form 2 printer
Procedure
3D Modeling
- Save your file in STL format in Fusion 360
- Download and open Preform
- Import your file into a new workspace and scale and orientate as needed
Scale and Orientate
3d Modeling Cont.
- Click on the Click to Print button to allow the software to perfect the supports and print time required
- If the Print display at the bottom of the workspace still shows red follow these steps (otherwise skip to step #) :
SLA Printing Set up
Before sending your file to the printer be sure to check the resin container and make sure the vent is open which is seen as a small black cap that is flipped open nest to the resin container.
Upload your file using the USB cable attached to the printer.