Difference between revisions of "ECE-370: Distance Sensor Hookup to uController and "Speed" Encoder Wheel"
From Lofaro Lab Wiki
| Line 1: | Line 1: | ||
| − | Due: 2019-02- | + | Due: 2019-02-25 |
Make an encoder for speed control. Using one IR sensor and a 3D printed encoder wheel calculate the speed of the output shaft of your motor. The encoder wheel should be attached to the motor shaft (pre gearbox). The IR sensor should be calibrated to measure the on/off state by when the rotor spins. This will be explained in class in detail. | Make an encoder for speed control. Using one IR sensor and a 3D printed encoder wheel calculate the speed of the output shaft of your motor. The encoder wheel should be attached to the motor shaft (pre gearbox). The IR sensor should be calibrated to measure the on/off state by when the rotor spins. This will be explained in class in detail. | ||
Revision as of 21:24, 17 February 2019
Due: 2019-02-25
Make an encoder for speed control. Using one IR sensor and a 3D printed encoder wheel calculate the speed of the output shaft of your motor. The encoder wheel should be attached to the motor shaft (pre gearbox). The IR sensor should be calibrated to measure the on/off state by when the rotor spins. This will be explained in class in detail.
Todo:
- Show me the motor mount
- Show me the IR Sensor mount
- Show me the calculated speed via the serial terminal
