View source for Add USB Ethernet to your Raspberry Pi Zero W

This tutorial is based on: [https://learn.adafruit.com/turning-your-raspberry-pi-zero-into-a-usb-gadget/ethernet-gadget https://learn.adafruit.com/turning-your-raspberry-pi-zero-into-a-usb-gadget/ethernet-gadget]
= Prerequisites =  
You must have the following:
* Raspberry Pi Zero W
* Raspbian Jessie (or Jessie Lite) installed after the May 2016 release
* USB Cable

= Steps =
== Step 1. Edit config.txt & cmdline.txt ==
Insert the SD card into your computer.  Use a text editor to open up the config.txt file that is in the SD card post-burn.

Go to the bottom and add the following to the last line to <b>/boot/config.txt</b>:
  dtoverlay=dwc2

Save the config.txt file as plain text and then open up <b>cmdline.txt</b> After <b>rootwait</b> (the last word on the first line) add a space and then:
  modules-load=dwc2,g_ether

== Step 2: Log into your Pi Zero==
Insert the SD into your Pi Zero, connect the console cable, power the Pi & log into via your normal method.  To check to see if your USB Ethernet came run the following:
  ifconfig -a
You should see <b>usb0</b> in the device list.

== Step 3: Login ==
You can now login via PUTTY or a BASH terminal.  The only difference is now your domain is different.  For example:
  ssh pi@HOSTNAME.local
Where HOSTNAME is your Pi's hostname.